 |
Welcome
to Celica.net. We hope you enjoy all we have to offer, there
will be much more in the coming future, so have fun and enjoy
the Toyota Celica. |
|
RS300
Ignition Controlled Auto Lock
|
The
RS3200 is factory-set to automatically lock you vehicle's
doors when you turn the ignition key to "ON"
or "START", and unlock the doors when you
turn the key back to "ACC" or "LOCK".
To change the programming of this feature, follow the
procedure below. (Start the procedure in the driver's
seat.)
|
|
|
1.
Before you begin:
Open the driver's door.
Remove the key from the ignition switch.
|
|
2.
Start the Programming Procedure. (Complete all steps within
30 seconds)
a. Insert the key into the ignition switch and turn it
from LOCK to ON 5
times (ending at ON).
b. The tail and marker lights flash once, and the buzzer
chirps once. If this
does not happen, start over.
c. The Status Monitor's LED (or the engine immobilizer
LED turns on for 30
seconds.
|
|
3.
Select the Operating Mode & Complete the Programming
Procedure.
a. Close the door = IG. Controlled Door Locks ON
or
a. Close then open and close the door again = IG controlled
Door Locks OFF
b. Turn the ignition key back to LOCK.
c. The tail and marker lights flash once, and the buzzer
chirps once if the
system was set for IG door lock control ON, twice for
IG door lock control
OFF. If this does not happen, start over. Programming
is now complete.
|
|
|
|
|
| |
|
|
Comments
about the website should be addressed here.
If you have technical or specific questions please use the messageboard!
Want to advertise on celica.net? Find out here!
|
 |
|
|
|
 |
