RS300 Passive Arm / Disarm

When the RS3200 is programmed to Passively Arm, the system will arm after the ignition key is removed and all doors and the trunk or hatch are closed; you do not need to lock the doors. When you come back to your vehicle and open a door, you must insert the key into the ignition switch and turn it to "ON" during the Entry Delay (0, 15, or 30 seconds), or an alarm will be triggered. If you lock the doors, regular arming will override Passive Arming; there will be no entry delay.

Passive Arming On/Off Selection, Entry Delay Time Selection

The RS3200 is factory-set to not Passively Arm. to change the system's operation for Passive Arming operation, as well as adjust the Entry Delay time, follow the procedure below. (Start procedure sitting in driver's seat.)

1. Before you begin:
    Close all the doors, and the trunk or hatch.
    Unlock all the doors with the inside lock switch.
    Remove the key from the ignition switch.

2. Start the Programming Procedure. (Complete all steps within 30 seconds)
    a. Using the remote control, lock, then unlock, the doors 3 times.
    b. Open the driver's door.
    c. Lock, then unlock the driver's door handle lock button 3 times.
    d. The system lock the door in 2 seconds; if this does not happen, start over.
    e. Unlock the driver's door handle lock button.

3. Select the Operating Mode & Complete the Programming Procedure.
    a. Close, then Open the door:
            2 times = Passive Arming OFF

            3 times = Passive Arming ON,
                           0 sec Entry Delay

            4 times = Passive Arming ON,
                           15 sec Entry Delay

            5 times = Passive Arming ON,
                           30 sec Entry Delay

    b. Lock then unlock the driver's door handle lock button 1 time.
    c. The system locks the door in 2 seconds; if this does not happen, start over.
    d. If the system successfully locks the door, programming is now complete.