The RS3200 is factory-set to unlock the driver's door when the UNLOCK button is pressed on the remote control, the unlock the remaining doors when the UNLOCK button is pressed again within 3 seconds. You may change the programming so all doors will unlock at once with the UNLOCK button is pressed by following the steps below. (Start the procedure in the driver's seat.)

1. Before you begin:
    Open the driver's door.
    Remove the key from the ignition switch.

2. Start the Programming Procedure. (Complete all steps within 40 seconds)
    a. Insert the key into, and remove it from the ignition switch 2 times.
    b. Close, then open the driver's door 2 times.
    c. Insert the key into, and remove it from the ignition switch 1 time.
    d. Close, then open the driver's door 2 times.
    e. Insert the key into the ignition and leave it in.
    f.  Close the driver's door.
    g. Turn the key from LOCK to ON 4 times (ending at LOCK).
    h. Remove the key from the ignition switch.
    i.  The tail and marker lights flash 4 times and the buzzer chirps 4 times.
    j.  The doors will lock and unlock 1 time. If this does not happen, start over.

3. Select the Operating Mode and Complete the Operating Procedure.
    a. Press and release both LOCK & UNLOCK on the remote at the same time.
    b. Press and release the UNLOCK button once for all doors unlock.