CelicaTech Main Page  CelicaTech Member List CelicaTech Image Gallery CelicaTech Data Garage Chatroom CelicaTech Forums Search CelicaTech Forums Contact CelicaTech
+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    呉音^ nerdy asian kid 唐音 l0ch0w is a splendid one to behold l0ch0w is a splendid one to behold l0ch0w is a splendid one to behold l0ch0w is a splendid one to behold l0ch0w is a splendid one to behold l0ch0w is a splendid one to behold l0ch0w is a splendid one to behold l0ch0w's Avatar
    l0ch0w has donated to the forums!

    Join Date
    Jan 2011
    Location
    Colorado Springs
    Posts
    435
    Images
    7

    Default ST185 IG1 and IG2 connectors (big grey and big white one)

    Its always been easy to track down the pinout locations of the ECU, but also on the engine harness are two larger but equally important connectors that go to the body harness...

    It was important for me to know the purpose of each of these connectors because I am attempting to streamline my entire wiring harness, and make it "better" than OEM. I also am running a fully standalone engine management system, and it was important that I figure out what some of these connections were for so that I could retain complete stock functionality. Two of the pins are unknown... I searched through the whole of the wiring diagram and I could not find any mention of IG2 pin3 or pin17... I know the white-red wire goes to the check connector, and I believe the same for the white-blue wire... so they arent that important, but ill just make sure to reconnect them back in the same way I found them. CKC means check connector, and some of them I dont know what they mean, but I can tell you where they go and speculate on what their purpose is, really the most confusing seems to be the white-blue series of wires that go to the cruise, coil, CKC, and airbags.

    Anyways, here are the pin numbers for the two connectors as described in the BGB (you are looking at the ones labeled IG1 and IG2). Note that the numbers reflect as if you are looking into the open end of the female connector.



    Uploaded with ImageShack.us

    Below are the descriptions of most every pin. I had to spend quite a bit of time tracking all of these buggers down in the wiring diagrams, but here it is nice and compiled for you.

    IG1:
    PIN------Description----------Wire color

    1-----------NOT USED------------
    2------IDL (TPS switch)------Pink
    3------Speed sensor---------Blue
    4------A/C Switch----------- Black-White
    5-----------NOT USED------------
    6------VR3 (Cruise)----------Green-Black
    7------VR1 (Cruise)----------Green
    8------MC (Cruise)-----------Red-Green
    9-----------NOT USED------------
    10----------NOT USED------------
    11-----Ground---------------Brown
    12-----Oil Light (Gauge)-----Yellow-Black
    13-----Water Temp (Gauge)-Yellow-Green
    14-----Tach (Gauge)--------Black
    15-----Turbo Pres (Gauge)--Red-White
    16-----L (Cruise)----------- Green-Black
    17-----VR2 (Cruise)---------Green-Red
    18-----MO (Cruise)----------Pink-Black

    IG2:
    PIN------Description----------Wire color

    1-----------NOT USED------------
    2-----------NOT USED------------
    3------Unknown CKC?--------White-Blue
    4------Backup light sw. in----Red-Blue
    5------Fuel Cut--------------Green
    6------TC CKC---------------White-Blue
    7------+12V Battery----------Pink
    8-----------NOT USED------------
    9-----------NOT USED------------
    10----------NOT USED------------
    11----------NOT USED------------
    12-----Airbag CKC------------Brown
    13-----Backup light sw. out---Red-Black
    14-----Ground (Gauge)--------Brown
    15-----IG from alternator------Black-Red
    16-----Battery light-----------Yellow
    17-----Unknown CKC----------White-Red
    18-----+B Switched power----Black-Yellow
    19-----Fuel Pump CKC--------Blue-Black
    20-----Starter switch---------Black

    I can get a more accurate description of two unknown CKC wires later, i just dont really feel like ohming out my check connector at the moment...

  2. #2

    Default

    I would imagine it be the same for the non turbo models except without the extras a turbo will have like the turbo gauge ect.
    Kinda wish i found this earlier its useful jaja
    1990 Celica GT

    To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Top Member List Chat Forum Search Contact Top