Forum: Custom Engineering/Design/Fabrication

just thought i'd post some of the stuff i've posted over on the MR2 boards over the years. this how-to assumes two things: 1. you have the fuel pump to support these injectors 2. you have the engine management to control these injectors.

I'm not sure if this is the right forum but I was asked to write a post about engine swap wiring, so here it is. Keep in mind that this is not a step by step guide to wiring a 3SGTE swap, but is a general guide to wiring ANY Toyota swap. Also, yes, I am willing to help people out over email with...

Ok, apologies for the length of time its taken to do this and its still not totally complete, but having said that, its a sight more information than i had available to me when i took this on and i think its about time i gave as much as i can remember to all of you. I will attempt a wiring writeup...

Here's the backstory...I bought an '86 Celica GTS from a friend of mine with a rod knock for $400. It's a pretty clean car and I was hoping to just pull the pan and roll some new bearings in. Pulled the tranny and got the pan off and found that there was NO bearing left (other than the small amount...