CelicaTech Main Page  CelicaTech Member List CelicaTech Image Gallery CelicaTech Data Garage Chatroom CelicaTech Forums Search CelicaTech Forums Contact CelicaTech
+ Post New Thread
Page 11 of 25 FirstFirst ... 9 10 11 12 13 21 ... LastLast
Threads 201 to 220 of 499

Forum: Alltrac / GT-Four

The 4WD rally-inspired models: chassis codes ST165, ST185, and ST205

Sub-Forums Last Post

  1. Sticky Thread Sticky: How To: Dyno in 2WD Mode

    The Alltrac/GT4 transmission can be switched into an "FF" mode for certain purposes. Specifically, the ST165 and ST185 transmissions have this capability. The ST205 transmission DOES NOT. Although some question the safety and reliability of operating the car in this mode, it is generally very...

    Started by ChrisD‎, 04-23-2010
    2 Pages
    1 2
    • Replies: 25
    • Views: 6,348
    08-30-2012 Go to last post
  2. Sticky Thread Sticky: ST185 CS / RC Front Crash Bar & Bumper Thread

    hi all, not sure if that is what its called but the metal bar behind the front bar... well im just wondering if anyone has photos of a carlos sainz version? i am interested in getting a cs front bar and wondering if i need to custom make one or what :P any help would be greatly appreciated

    Started by D3animation‎, 05-17-2010
    • Replies: 13
    • Views: 8,923
    02-12-2011 Go to last post
  3. Exclamation Sticky Thread Sticky: Exclusive offer for prior "Gold" members - Limited Time Only!

    All current/active members of AT.net with a Gold membership that are willing to make the switch to CelicaTech will receive a 1 year membership FREE. Here is what you will get: "C-Tech Supporter" (Yearly) -1000 combined message limit in PM box -Able to use an Avatar -Can create...

    Started by Shadowlife25‎, 04-23-2010
    • Replies: 11
    • Views: 3,377
    05-21-2010 Go to last post
  1. So I just managed to completly mess up my car!

    I shoundn't have fiddled with the darn thing! I ave been getting a CEL after maybe 15 minutes of operation since I got this car. So I wanted to figure out what the code was and did the jumper thing to get the code. So I did the jumper thing and got four flashes, a pause and then two...

    Started by klapa‎, 04-23-2011
    • Replies: 9
    • Views: 894
    04-24-2011 Go to last post
  2. What parts fit my car?

    I have a 1991 - and my 1991 is actually a 1990 - as the DOM on my door pillar indicates 08/90. Yet - when you look at the parts that are different - the "borderline" is 08/90 - which makes me a little nervous being right "on the border" like that. All of the above applies to my chassis only -...

    Started by klapa‎, 05-14-2011
    • Replies: 9
    • Views: 596
    05-15-2011 Go to last post
  3. Euro GT4 6 speed trans

    I was at boost for boobies at Modern Automotive Performance in the cities here in Minnesota and ran into a guy with an All-Trac and he was saying there is a 6 speed trans from Europe. Has any one heard of the same thing?

    Started by allTRACway‎, 06-08-2013
    • Replies: 9
    • Views: 431
    06-17-2013 Go to last post
  4. Getting the trans back on the engine

    Was trying to do this for 6 hours yesterday. Engine and trans are out of the car. The engine is on a hoist but also have dollys or can put on floor. Tried lifting the trans onto the engine. Tried setting the trans on a chair and manuvering them together. Tried it with both of them on the ground....

    Started by 90ToyAllTrac‎, 07-23-2010
    • Replies: 8
    • Views: 722
    07-25-2010 Go to last post
  5. where does this go

    just got the alltrac back from fixing the shifter cable.i go to put the lower dash and center console back together. when done i had no radio no dome light no door lights no clock and no low beam on the drivers side,will do high beam.i have searched and checked all the fuses and even replaced them...

    Started by TXcajunman‎, 05-19-2010
    • Replies: 8
    • Views: 792
    05-19-2010 Go to last post
  6. Shelled or Unshelled that is the question

    OK so its come time for me to replace some suspension bushes. I'm going to start with the front. I'm also going to be a test pilot for the Whiteline Plus Chassis Control bushes (i think unless someone's already using them). Now on their website they list two options. Shelled or straight poly. I...

    Started by GrpA4‎, 06-02-2010
    • Replies: 8
    • Views: 854
    06-14-2010 Go to last post
  7. Making my own straight intake

    Going to relocate my battery and fab my own intake to use with my 3" Cone filter. Does anyone know what thickness of aluminum I should use for the pipe? I have some material I can use to insulate the pipe, so I think I can go with something fairly thin. Also, does anyone have the diameter of...

    Started by alistair‎, 05-16-2010
    • Replies: 8
    • Views: 916
    06-02-2010 Go to last post
  8. Will my car be ok if I run off the dp?

    I was going to go to a local track near me and I was going to have my 3" exhaust made sInce I just bought my muffler and 3" flex pipe but something came up right now so it has to wait a bit. My question is: would anything under my car burn up or be damaged if I disconect my stock midpipe and just...

    Started by lalojamesliz‎, 10-02-2010
    • Replies: 8
    • Views: 684
    10-06-2010 Go to last post
  9. 205 ecu with 185 engine?

    I've heard of it being done before, but what're the catches? Does is have everything the 185 ecu has? I heard it deletes the stupid MAF unit which is a plus. But what else would be considered an upgrade by getting this ecu? Would there be any downgrades? Would I gain any horses? Other than deleting...

    Started by ericfragola‎, 10-17-2010
    185, 205, ecu upgrade, maf
    • Replies: 8
    • Views: 971
    10-20-2010 Go to last post
  10. Final Drive Modification

    As some of you know, the final drive of an RC gearbox is 3.933, while the standard E150F has a 4.285. So by swapping the 4.285 final drive into the RC box, you lower the gear ratio, increasing acceleration. Worth it? If I wanted to do this I could simply swap the output shaft, ring gear...

    Started by DudeMan‎, 10-18-2010
    • Replies: 8
    • Views: 670
    10-22-2010 Go to last post
  11. whatre these alterations made to my 185 harness?

    good news so the 185 harness i have is in awesome condition. nothings chopped off of it. the chopped piece i was looking at was off of a different harness. im a little confused though. so i need some clarification. ok so, towards the ecu side of the plugs, there about 7 blue pieces of tape...

    Started by ericfragola‎, 10-21-2010
    185, ecu, harness, pins, rewiring
    • Replies: 8
    • Views: 811
    10-21-2010 Go to last post
  12. Dump Valve fitting

    Hi all, I'm new to this site so please easy on me. I've just bought my 3rd GT4, first one blown head gasket, 2nd one bottom end went, hopefully this baby will with me for long time. Now, to most of you maybe silly question but can anyone tell me where small pipe goes from dump valve? I've got it...

    Started by shoichi27‎, 10-22-2010
    • Replies: 8
    • Views: 562
    10-25-2010 Go to last post
  13. Do I need a USDM st185 ECU????

    I have a JDM st185 ECU and a USDM st165 ECU. Can I combine those to run my JDM st185 in my California st165 chassis or does it need to be USDM to USDM ECUs?

    Started by shreddr69‎, 04-13-2011
    • Replies: 8
    • Views: 994
    07-20-2011 Go to last post
  14. Video of my Celica starting

    Just thought i would share the link of my ST185 so far have got the ST215 3SGTE in and running .... just in the process of hooking everything up. In the video i have a full 3" exhaust from the turbo with a high flow 100 cell cat and the HKS Cat Back System. More videos and pictures to come as i...

    Started by D3animation‎, 05-30-2011
    • Replies: 8
    • Views: 969
    07-14-2011 Go to last post
  15. ST215 3sgte into a st165

    So im contemplating doing a conversion in my st165.. cant find any 185 or 205 engines in aus at the moment but i have been offered a low k st215w complete engine w loom and ecu.. was wondering of anyone has done the conversion or any info on it..??

    Started by st165sa‎, 07-28-2011
    • Replies: 8
    • Views: 702
    07-30-2011 Go to last post
  16. Question Maf Sensor

    So I have seen people make just a straight pipefor there intake and just a regular filter... did the buy an after market maf sensor what?

    Started by jdm_celica_gts‎, 12-20-2011
    • Replies: 8
    • Views: 1,156
    12-26-2011 Go to last post
  17. Mystery sensor

    Anybody know what this is? Right by the drivers side engine mount.

    Started by jdm_celica_gts‎, 11-27-2012
    • Replies: 8
    • Views: 247
    12-02-2012 Go to last post
  18. Vibration at all speeds ST-185 All-Trac

    Hello all, I have a issue with a mystery vibration from the front end at all speeds. I tried tried replacing both front bearings, steering rack, tie rod ends and tires, and it still does it. The vibration only happens above 30 mph in gear and while coasting in neutral with the clutch in and out....

    Started by Blu4vu‎, 05-05-2012
    • Replies: 8
    • Views: 289
    05-20-2012 Go to last post
  19. MAF will this work for me st185?

    Wasnt having any luck here so posted on alltrac.net for an MAF for my 90 all trac. Whats the deal with this MAF? Looks aftermarket. Anyone know what the deal is with this and if if would work with my stock 90 all trac, JDM swap engine, 92 ECU. ? Thanks,

    Started by 90ToyAllTrac‎, 05-30-2012
    • Replies: 8
    • Views: 349
    06-18-2012 Go to last post
  20. st205 turbo problems

    hi everyone i am having toubles with turbo pressure when its is cold it will boost up to 14psi but when it warms up, the max i can hit is 4 psi i have checked for leaks and cannot find anything i need help

    Started by kcameron‎, 06-21-2012
    st205
    • Replies: 8
    • Views: 603
    07-03-2012 Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 2 users browsing this forum. (0 members & 2 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 10 replies or 50 views
Hot thread with unread posts
More than 10 replies or 50 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Top Member List Chat Forum Search Contact Top