View Full Version : flywheel for 3sgte

03-07-2016, 07:18 PM
Hey guys, i recently picked up a 4th gen caldina motor and am doing the swap. i'm about to order a flywheel. but was unsure if there were any differences between the 4 generations of 3sgte. kinda like 6 and 7 bolt trannys for dsms. thanks in advance guys.

03-07-2016, 09:29 PM
You'll need a flywheel from either a SW20 or ST185/ST205. I can't remember what the difference was with the ST165 1st gen was. It's either a 6 bolt instead of 8 bolt or 8 bolt with different hole spacing. I discovered this the hard way when I did my swap :-\

Here's a P/N cross check for you. The Caldina 3sgte flywheel part number is 13405-74080. It cross checks back to any USDM SW20 (MR2 turbo) or USDM ST185. The JDM/EDM versions also work but if you're wanting to just buy a new flywheel at the store you can use the SW20 or ST185 flywheel.


03-08-2016, 04:47 AM
Thank you very much!