View Full Version : Removing bumper signals/indicators ST185

Blue Scapegoat
07-17-2015, 04:45 PM
I bought some JDM clear turn signals and some matching aftermarket textured clear ones for the bumper. Top ones are easy enough to replace, but how do you get the lowers out? There's one phillips head screw to the outside, then it should pull out and away. Tabs hold it in on the inside edge.

But the body of the light on the inside is way too large to allow me to pull the lamp out far enough to slide it off the tabs. By an inch and a half at least.

It's a carlos sainz bumper if that makes any difference.

07-17-2015, 05:12 PM
Remove the screw and pull from the inside. I sometimes use a screw driver to help. You won't be able to get them very far before you'll need to unscrew the bulb housing

Sent from my Nexus 6 using Tapatalk

07-17-2015, 05:50 PM
I second the screwdriver to pop it out. Just did it this past weekend

07-18-2015, 01:51 AM
Like mentioned, you unscrew them, then you take a flat head screw driver and pop them out where the tabs hold them in. Installation is just as easy you pop them back in, then screw them down. I do just did this this past weekend.

07-19-2015, 09:52 PM
What Murg said.

07-20-2015, 11:58 AM
What Nitro said but I did mine a year ago for shitz n gigglz :)

Blue Scapegoat
07-22-2015, 06:41 AM
Yep super simple, I was definitely over thinking it. I was just afraid of cracking that bumper. Thanks guys.

Now I just need to figure out why it's running like crap

07-26-2015, 08:40 PM
Now I just need to figure out why it's running like crap