PDA

View Full Version : Tie Rod Install with pics



pdqubet
04-05-2013, 11:23 PM
This is my '93 GT Convt. This just might be the dumbass question(s) of the week. Does this look properly seated? Should the boot clamp (wire) go farther in the hole or stop right where it is? I couldn't remember how the old tie rod ends looked before I knocked them out. My torque wrench has gone missing, so before I go out for a test drive, I wanted to ask you smart folks if this looks correct. Thanks for your help.

Peter
NC


32423243

KoreanJoey
04-05-2013, 11:55 PM
It's taper fit so just make sure it's pretty tight (I just use an impact wrench).