PDA

View Full Version : Cylinder head questions



92 celica
02-14-2013, 04:52 AM
So I cracked my cylinder head I was gonna use for my rebuild when my co worker hit my crash cart/ table with a forklift -.-
Anyways I have a core motor from a 98 with a spun bearing in it but the head is in good shape

My question is will a 98+ head mate to a 93 block and will a disturbator bolt up to it since the cam shaft dose have the slice in it but its plugged on the end

Flux
02-14-2013, 05:09 AM
AFAIK, it will work.
Just use the old distributor and you'll be fine.

93celicaconv
02-14-2013, 02:35 PM
I agree - it should work fine. As stated by Flux, just pop out the plastic distributor hole plugs to reuse your current ignition system. You may have a cam position sensor at the timing belt end of the 98+ engine, so just don't use that sensor and reuse your 93 timing belt covers. You should be good. Of course, still go through that 98+ head (pressure checks, lap valves, replace valve stem seals, check for flatness and machine to flatness specs, replace camshaft oil seal, etc.).

92 celica
02-14-2013, 02:57 PM
Thanks guys saved me a lot of headache with this