View Full Version : Double checking part#

Hipster Lawrence
02-20-2012, 06:29 PM
The little white bushing on the rack. 86 mr2.

i have 45522-17020 is this correct?

Aaron Willis
02-20-2012, 06:39 PM
Absolutely correct. Don't forget a claw washer, 90214-14002, so you can reinstall the inner tie rod properly.

Hipster Lawrence
02-20-2012, 06:46 PM
I was goin back with aftermarket tie rods so thy should come with washers.

Aaron Willis
02-20-2012, 06:49 PM
I know OEM inners typically do, but I have seen some aftermarket that do not. Double-check before you start the job...

Hipster Lawrence
02-20-2012, 06:51 PM
I can do this job with the rack in the car right. Just take both tie rods out? I've edone it on my ae86 but the rack was out

Aaron Willis
02-20-2012, 07:15 PM
You only need to take the passenger side inner tie rod end off the rack to get to that bushing. I wasn't able to do that in the driveway without removing the rack. You may have a better tool selection or facilities than I had access to at the time.