PDA

View Full Version : 93 tailight remove - where are they attached?



terryd
05-24-2011, 01:51 AM
removed screw from top of light (next to rubber trim)

cannot get other side out --- is there another bolt/screw?

Physlis
05-24-2011, 01:53 AM
There are 2 screws under each side-marker light that you need to remove. Once inside there are 2 clips that hold the bottom of the lights in, be careful not to break them as they can be fragile.

I think that's what you're looking for anyhow, hope that helps.

terryd
05-24-2011, 02:01 AM
Thx. Do the side-marker lights (red) just pop off w/ a screwdriver or something? They sound like they're going to crack when I try to pry them out.

Physlis
05-24-2011, 02:06 AM
Yea, they're held in by 2 prongs on one side and a metal clip on the other side. The clip is where you need to pry at and IIRC is on the inner side of it and should come out easily, if it doesn't start coming out try the other side.

Galcobar
05-24-2011, 08:18 AM
Tape-wrapped No.1 flathead screwdriver, inserted at the seam between the side marker and the turn signal. Pry with the tip towards the side-marker.

underscore
05-25-2011, 04:51 AM
I just push down on the "front" edge of the marker, which lifts the rear edge up slightly, then I can usually get enough of my finger under it to pop it out. If you need to slip a tool under the rear edge, go with the widest thing you can to evenly distribute the pressure.