PDA

View Full Version : ATS throttlebody inlet



fdfx3
02-13-2011, 02:12 PM
Does anyone know if you can run the throttlebody inlet with the stock water to air intercooler found on the cs?

Nitro_Alltrac
02-13-2011, 02:28 PM
The ATS kit is metal like the one on the MR2, correct? If so, I'd think you could but you'll have to have a silicone or rubber connector and the intercooler will probably sit at a slightly odd angle. When I got my 185, it had a chopped up MR2 adapter and the stock ATA intercooler. It worked, but the intercooler was sitting at a weird angle.

ChrisD
02-13-2011, 02:54 PM
Nope. Your best bet is to just use the rubber coupler from an ST165 model. It is identical to the ST185CS coupler. This coupler has a wide opening matched to the outlet on the intercooler and will allow you to fit the IC perfectly.

Mafix
02-14-2011, 05:12 PM
you can't use the ATS inlet with ANY top mount intercooler.