View Full Version : ineed a base map for 92 5sfe to use with emanage ultimate

06-11-2010, 07:55 AM
hey guys, i just bought the greddy emanage ultimate for my 92 celica gt with a 5sfe. does anyone have a base map that i could use so that i can atleast get my car to start and run so i can drive it to the shop for tuning?


06-21-2010, 09:32 PM
Sorry missed this. But isn't emanage a piggyback, thus using the stock map as the "base" which you then enter +/- from there?

06-22-2010, 03:43 PM
how can i use the base from my stock ecu? i havent been able to figure that part out yet, im still learning as i go

06-22-2010, 05:10 PM
Everything set at 0 should be the equivalent of no changes to the stock maps. Emanage just does a +/- from the stock maps, so you shouldn't have to do anything to use the stock "base" map.

06-22-2010, 05:59 PM
but like when i click on parameters, under the vehicle tab on the engine code, what would i select since there is no 5sfe?

06-23-2010, 05:46 AM
Hm. What Toyota engine codes does it list? Is this for a turbo'd 5s?

06-23-2010, 06:50 PM
it has for the 3sge and the 3sgte, and mine is a turbo'd 5sfe

06-23-2010, 07:07 PM
What map sensor are you using? It will want to determine the voltage for the load signal...the 3SGTE/3SGE won't work probably b/c they are 5-0V, while most map sensors are 0-5V.

06-23-2010, 07:17 PM
at the moment i have the stock MAP, i purchased the 2 bar map from a mr2 turbo but havent tried it yet