PDA

View Full Version : how to get rid of small dents?



lue
04-27-2010, 07:29 PM
what's the best way to get rid of a dent(DIY)?

187flatliner
04-27-2010, 07:32 PM
paintless dent remover tool.

lue
04-27-2010, 07:54 PM
paintless dent remover tool.

a picture of how it might look like?

187flatliner
04-27-2010, 07:57 PM
i dont have a pic but you can find it at any parts store or even fred meyers...it really only works for smaller dents tho.....how big is this dent?

lue
04-27-2010, 08:37 PM
i dont have a pic but you can find it at any parts store or even fred meyers...it really only works for smaller dents tho.....how big is this dent?

pretty small. looks like a rock hit it but there is not paint chip or crack either on it..

187flatliner
04-27-2010, 09:03 PM
just go to a parts store and ask for a pdr tool and then follow the directions on the box....takes about a half hour for each dent tho.

lue
04-27-2010, 10:52 PM
those three small dents on the rear quarter panel. that's a hard place to get dents out unlike the fenders or hood. i just took it in and it will cost about 80-100 bucks to get rid of the dents.

kungFUBAR
04-27-2010, 11:35 PM
...bondo.

























:D j/k pdr tools ftw!

joe's gt
04-28-2010, 03:00 AM
There are dent removers at most autoparts stores. They consist of a hot glue gun type deal. You put the glue on the tool and immediately stick the tool in the middle of the dent, then you either pull it out if the tool is a t-handle or screw down the nut if it is one of those pullers that braces itself against the panel.