View Full Version : Instrument panel question

01-24-2010, 12:31 AM
is it hard to remove it so i can replace the bulb?
And what exactly do i have to take off to get to it?

01-24-2010, 01:01 AM
CAUTION: When removing driver-side air bag, DO NOT pull on air bag
wiring harness. When storing air bag, ensure pad surface
faces upward.

Removal & Installation
1) Ensure front wheels are in straight-ahead position. Turn
ignition switch to LOCK position. Disconnect and shield negative
battery cable. Wait at least 90 seconds before continuing. Remove
steering wheel.
2) Remove steering column covers. Remove plastic screw cover
from instrument panel lower finish panel and remove 7 retaining
screws. Pry off lower finish panel from around ignition
key bezel and steering column.
3) Remove 4 upper cluster finish panel retaining screws. Pull
upper cluster out far enough to disconnect harness connectors and
speedometer cable (if equipped). Pull out register No. 1 finish panel.
Remove instrument cluster. Remove 2 center cluster finish panel
retaining screws. Pull out center cluster finish panel. To install,
reverse removal procedure. Before installing steering wheel, center
spiral cable.