PDA

View Full Version : st185 to 4agze



rodney
01-22-2010, 06:16 AM
Good day, will the st185 bellhousing fit onto a 4agze gearbox, i have noticed that it is a e-series, i am fitting 3sgte motor onto a fwd gearbox, anyone has done this before?

Shadowlife25
01-22-2010, 09:42 AM
No it will not work.

If you want to use a FWD trans you can use the Solara v6 trans or the 5th gen 5sfe tans.

rodney
01-23-2010, 05:50 AM
thanks for the feed back, i have the e58 4agze tranny, and by comparison, without the transferbox, they look identical, i am sure the bellhousing might 50/50 work out, it is going to save alot for me, i dont need to customise new driveshafts, besides the bearing bracket for the right hand side shaft, thats should not be a problem.

Shadowlife25
01-23-2010, 08:05 AM
I know this sounds dumb, but could you potentially clarify your question and tell exactly what your plans are? (engine/trans combo)

I would hate to give you incorrect advice because I misunderstood the question. :)

Thanks much, and WELCOME!

rodney
01-27-2010, 06:56 PM
Hi, sorry for the late response, at the moment i have a 4agze motor and e58 gearbox with custom axles, i want to upgrade to 3sgte, i wanted to know if i swop bell housing from a st185 4wd gearbox onto e58, will this work?