PDA

View Full Version : Thinking of selling the MK1



renegadex
09-30-2009, 11:07 PM
Hey guys just wanted to post this to get kind of a push in the right direction. I have been thinking about selling my MK1 on and off now for some time. As some of you guys know I have 3 cars that I'm working on at the moment. The Supra and my two 2's. I'm thinking about simplifying a little and since the Supra isnt really mine anymore I only have one other car I'm willing to part with. If I were to sell it I would be looking for around $4400.

The good:
-New ball joints
-New inner and outer front tie rods
-New twosrus rear tierods
-New poly bushings
-New Tokico Illuminas
-New generic coilover kit(forget the spring rates, can be easily converted back to use standard springs(I have a set of eibach pros))
-New goodridge ss brake lines
-New poly engine mount inserts
-New front strut mounts
-New Hight and Tight rear sway bar
-New adjustable end links x4
-New cap and rotor
-Newish Magnaflow muffler and 2.5" mandrel bent pipe with an Audi TT resonator
-Black top 20V
-BT20V clutch and flywheel
-C56 Trans
-15" 5 spoke honda wheels with enkie ceter caps with azenis
-T3 Velocity stacks
-Twos r us engine lid prop
-MK2 93+ shifter
-Recaro Seats
-Mint black interior
etc.

The bad:
-couple of small dents
-a very small amount of rust under the rear section of the side skirt on the right side.
-engine needs new rings( still runs fine, just burns a little oil)
-AC and heat dont work(AC will work with AC compressor installed, heat needs heater lines under car replaced (I have new copper lines from toyota) and servos in the hvac system fixed.)
-drivers side window motor gear just broke a tooth

If I sell it I would give all of the other stuff I have for it with the car.
such as:
-SC engine lid
-LED spoiler
-'85 drivers side front fender
-New copper heater lines(the ones that run under the car)
-New BT20V Toyota engine seal kit
-set of 4 14" toyota mesh wheels
-set of 4 14" stock triangles
-16v 7rib enigne
-16v ac compressor (needs new housing seals)
-BT20V ac compressor
-BT20V fuel pump
-various other body parts
-extra drivers side door pannel and window switch
-extra pass side door pannel
-eibach pro springs
etc.

click the link in my sig for some pics on the whole ordeal
http://img25.imageshack.us/img25/6976/10632560029080583512041.jpg
http://img34.imageshack.us/img34/6541/10632560029095553512041.jpg
http://img8.imageshack.us/img8/1820/10632560029105533512041.jpg

Hipster Lawrence
10-01-2009, 01:19 AM
You should have mentioned this when I was looking for a mk1.

$4400 is alot for a mk1. I think it's worth more but mk1 owners are cheap asses. Prepare for sub 2k offers. Good luck but selling it is a mistake IMO.

renegadex
10-01-2009, 03:43 AM
Well I wasn't really too sure about it the last time, still not too sure this time though it looks like I'll probably be selling it. I think 4400 with all of the stuff I'm throwing in with it is a good price. Before I had offers of 3000 just for the car.

andy
10-01-2009, 03:52 AM
if that fetches moar than my 91 im gonna be all outa whack.

renegadex
10-01-2009, 04:54 AM
Celicas are everywhere
MR2s aren't

renegadex
10-15-2009, 10:19 PM
If you have an acount on MR2OC here you go: http://mr2oc.com/showthread.php?t=367072

If you don't, I'm selling it for $4400 OBO