PDA

View Full Version : Ryobi Drill Press



Sang
09-17-2009, 11:00 PM
Just picked it up! Came with a full set of titanium metal bits (more than i'll need) and 2.5" drill press vice. Found it on craigslist for $100, barely used over the past couple years. The guy used it to make a dozen or so brackets for his kit car that he had in the garage.

:woot:

Here it is after I got home...I have no where to put it...but I got it setup in the upstairs spare room that I use as an "office". So far I made a up a couple brackets to mount the fuse box in the trunk and redo the brackets on my fuel rail. Works great!

http://i264.photobucket.com/albums/ii191/Sang_Han/DrillPress.jpg

Once I drill up a few fuel rails, it would more than make up for the cost. Wish I bought it in the first place instead of paying out the ass at my machine shop!

Blackcloud
10-24-2009, 04:44 PM
nice. i say leave it in the kitchen. put a mixing paddle on it and make cakes!