View Full Version : 5s build update

05-28-2008, 07:35 PM
I just got all my motor parts back got pics will be posting as soon as i get a dock
for my camera. I have 6 hrs of port work 5 angle valve job decked .040 and my block is bored .040 over also I have all the boltons availble for the 5s

05-28-2008, 07:44 PM
Stock bottom end? :(

05-28-2008, 08:25 PM
its all stock but new the rods are polished as well as the crank, but thats it.

05-28-2008, 08:32 PM
its all stock but new the rods are polished as well as the cranks but thats it

Welp, let's see what you do on the dyno.

What are you going to use to tune?

05-28-2008, 08:40 PM
i plan on using emanage and my wideband. I cant wait to see what i put down!!

05-28-2008, 08:42 PM
When i need more i ll open the bottle

05-28-2008, 08:53 PM
You've got cams, too, right?

When you need more, you need to spin that sucker.

Mr Celica
05-29-2008, 12:48 AM
cams! can't forget cams!!! colt cams that is! get themmmmmmmm

05-29-2008, 09:49 AM
yep i got them from geoff a few months back 260 duration 345 lift

06-02-2008, 05:12 PM
is that the correct profile? what's the duration @.050? shim under tappets? are they hardwelds?

06-02-2008, 07:35 PM
its 213 @ .050

06-03-2008, 05:52 PM
with that profile i would expect the duration @.050 to be around 230*. are you using shim unders tappets. i didn't know geoff was offering that kind of grind.

06-03-2008, 08:58 PM
yes i got .030 shims

06-04-2008, 06:29 PM
good luck with the build. keep us posted.