mig407
03-05-2008, 06:03 AM
i made a modified plenum intake manifold on the stock runners and
finally got some preliminary runs on the the dyno... it made 336hp @ 11lbs of boost on 93 octane pump gas. i dont plan to run anymore boost till i break in the engine properly. after that ill re-torque the head put it back on the dyno and see what itll make at 25+ lbs of boost with race gas!!!!
current set up:
-arp main studs
-eagle rods
-wiseco forged pistons 9:0.1 comp .40 over
-3 layer cometic metal head gasket
-ARP head studs
-valve job, stock size ferrea valves, shimless buckets, engle valve springs, HKS 272 cams degreed, ATS adj cam gears.
-gutted and match ported tvis plate
-modified plenum intake manifold
-65mm bbk tb
-850cc inj x4, walbro pump
-tso4 cover 60-1/ .63 ar t3/t4
-stock ignition
-AEM pnp
my modified plenum intake manifold performed rather well, im happy with it..
i cant wait till the engine breaks in...
http://i74.photobucket.com/albums/i273/biglmiguel/dynosheet.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/SSPX0048.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/3sgteintake1.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/3sgteintake2.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/3sgteintake3.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/vwohsnap.gif
finally got some preliminary runs on the the dyno... it made 336hp @ 11lbs of boost on 93 octane pump gas. i dont plan to run anymore boost till i break in the engine properly. after that ill re-torque the head put it back on the dyno and see what itll make at 25+ lbs of boost with race gas!!!!
current set up:
-arp main studs
-eagle rods
-wiseco forged pistons 9:0.1 comp .40 over
-3 layer cometic metal head gasket
-ARP head studs
-valve job, stock size ferrea valves, shimless buckets, engle valve springs, HKS 272 cams degreed, ATS adj cam gears.
-gutted and match ported tvis plate
-modified plenum intake manifold
-65mm bbk tb
-850cc inj x4, walbro pump
-tso4 cover 60-1/ .63 ar t3/t4
-stock ignition
-AEM pnp
my modified plenum intake manifold performed rather well, im happy with it..
i cant wait till the engine breaks in...
http://i74.photobucket.com/albums/i273/biglmiguel/dynosheet.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/SSPX0048.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/3sgteintake1.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/3sgteintake2.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/3sgteintake3.jpg
http://i74.photobucket.com/albums/i273/biglmiguel/vwohsnap.gif