PDA

View Full Version : Don't know what to do ?? HELP



placilla
12-14-2007, 07:45 PM
Most of you have seen the photos of the water pump from the motor I bought for the 86 GTS (3SGE motor). Well I got the new motor yesterday to replace that one. First thing I did was remove the water pump to see what it look like and this is what I found. I took my old water pump out of the engine I am replacing, to see what it looked like, and it was clean, no rust or crap in there. This one looks better then the last one, but I just don't know if I should chance it. The place I bought it from, told me that the tested the motor and had no problems. They told me that the motor has been setting for a while, so I should expect that. Am I being too picky? It is a used engine after all. Will I be OK installing it and then doing a flush?

Thanks for your time.

celicatrd93
12-14-2007, 10:07 PM
damn that does not look to good. you should strip the motor down to inspect it more before installing it.

Carolina91GT-S
12-14-2007, 10:56 PM
agreed, you have problems.

Unless...they used ketchup instead of engine coolant.