PDA

View Full Version : 3SGTE TUrbo Manifold !!



deuce
01-18-2005, 08:23 AM
WIch turbo manifold is the best between these 2 on ebay...cause im planning on doing a 3sgte swap with that manifold ....anyone knows also how much horse will it produce aprox?

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7947840352&category=33632


http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=43808&item=4519404369&rd=1

skreem
01-18-2005, 12:33 PM
from what i can see they look identical. i would go with that first one, seller has more feedback and its cheaper so far.

G-man
01-18-2005, 03:17 PM
Or stay with the stock manifold because its good up to 400+ whp.

Snafu
01-18-2005, 07:18 PM
Well, if I were to make a tubular manifold, I'd rock a ram horn style manifold. Those look the best, plus you can use a variety of larger turbos.

Like this - Ram Horn (http://www.homemadeturbo.com/forum/index.php?board=2;action=display;threadid=33288)

If I were you, I'd rock the stock manifold until you want to run a larger turbo. Then fab up a custom manifold with a t3 flange and rock it.

Mike431635
01-18-2005, 08:29 PM
Same here snafu. I love the way those look. And it could even be possible to keep the AC on the 4AFE with one of those. Hmmmmm, if only I had access to a welder.

The JGS should be fine for a while, though.

Snafu
01-18-2005, 11:20 PM
I'm say'n. Not only do they look amazing, but you can get them pretty damn close to equal length.

Plus it's a lot cheaper to buy the parts and have someone else weld them than to buy one pre-fab'd.

Luni
01-19-2005, 12:10 AM
Wow.. they both look amazing.. they look like they are almost perfect in representation of the stock manifold (flange positioning).. Very nice.

ChrisD
01-19-2005, 01:12 AM
They look nice but won't produce any more HP...stick with the stock 3SGTE manifold, it does a really good job.

deuce
01-19-2005, 01:40 AM
Tnx you all for helpin me out on that....i guess i'll stick with the stock manifold and save up some $$...

tnx again...